Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may discover that your garage door opener has been giving you issues, so you need to repair it. You can fix it by changing a circuit board, a photo-eye sensing unit, the primary drive gear, or the set-limit switches. You can likewise examine if the security sensing units are working correctly.

Replacing a motherboard

Replacing a motherboard for your garage door opener requires a few steps and also devices. Initially, you need to turn off the breaker and also disconnect any type of cords. Next, open the motherboard cover. This will aid you to diagnose the issue and also figure out if you need a brand-new board. Next off, eliminate the old board and its wire adapters.

You can after that proceed to replace the circuit card. The substitute procedure is simple as well as takes around 10 mins. A new circuit board will set you back about $80. To safeguard your new motherboard from power rises, you can purchase a rise guard.

Replacing a photo-eye sensing unit

Replacing a photo-eye sensing unit can be a fairly easy task. Initially, eliminate the sensor from the door and see to it is positioned appropriately. If the sensor is angled by any means, it might not be getting the proper signal, which might be causing the strobe lights. If you discover that the photo-eyes are out of positioning, you may require to have a technician come and repair the problem.

The photo-eye sensor contains 2 pieces that place on the outside of the door tracks as well as toward the flooring. The photo eyes will have a tiny LED light and also need to be solid in color. If the light is blinking, its most likely the photo-eye is defective as well as will need to be replaced.

Replacing a major drive equipment

To change a garage door opener primary drive equipment, start by getting rid of the cap from the chain pulley. Next off, remove the two screws holding the drive gear to the gear setting up. Now, you can unfasten the 3 tension pins. Squeeze them from both sides and afterwards remove them. After that, separate the 3 cables from the garage door opener electric motor. These wires should be white, red, as well as blue.

Once you have gotten rid of the old equipment, mount a brand-new one. Make sure to oil it well. Put the new equipment right into the shaft, making sure to align the mounting holes. See to it the equipment and gear assembly are located correctly to guarantee smooth procedure. Next off, use a hammer and also a nail to drive a pin into the new equipment.

Adjusting the set-limit buttons

The very first thing you must do if your garage door is not working effectively is to inspect the set-limit switches. You might require to change them to make sure that the door shuts earlier or quits before it reaches the flooring. You can check this by taking a look at your garage doors manual or online.

To readjust the set-limit switches, youll need a screwdriver or outlet. Readjust the knob clockwise or counterclockwise up until the door goes up and stops, or lowers its range. To look for appropriate traveling distance, determine the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *

Back To Top